Zanussi Dishwasher Error Codes



Error CodesSolution
i30Error message i30 indicates a leak and / or water collecting at the bottom of the appliance.
i60Reset your appliance. If the cycle starts and operates normally, the problem has been resolved.
i80Reset your appliance. Check whether the appliance displays the same error message again or whether it has changed.
iC3Reset your appliance.
iC2Reset your appliance.
iC1Reset your appliance.
iCoReset your appliance.
iC0Reset your appliance.
BloDishwasher shows “BLO” on the display. It indicates that the child safety lock ("Blocking") is active. To deactivate, press the "Short" and "Prewash" buttons simultaneously.
Dishwasher beeps 3 times or the LED flashes 3 timesReset your appliance.
Cycle indicator light is flashing on the dishwasher
Cycle indicator light is flashing on the dishwasher. Cancel the previous cycle before programming a new one.
i51, i52, i53, i54, i55, i56, i57, i58, i59, i5A, i5B (i5H), i5C, i5D, i5E, i5FReset your appliance.
Zanussi Dishwasher - Description of the appliance

Zanussi Dishwasher – Description of the appliance

How to reset dishwasher?

  • Remove the plug for the dishwasher, wait 1 minute and plug it back in.
  • You can also turn off the power using the fuses on the panel/power switch.
  • If you have pulled the machine out and then pushed it back into position, it is important to ensure that no tubing is kinked or crushed and that the tap is fully open.
  • Turn on the dishwasher, select a suitable cycle and start it.
  • If the cycle starts and operates normally, the problem has been resolved.
Zanussi Dishwasher Control Panel

Zanussi Dishwasher Control Panel

Zanussi Dishwasher Troubleshooting

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. The dishwasher will not start or stops during operation. Press the On/Off push button to switch the dishwasher off and carry out the following suggested corrective actions.




TroublePossible cause Solutions
The programme does not startThe dishwasher door has not been properly closed.Close the door.
The main plug is not plugged inInsert the mains plug.
The fuse has blown in the household fuse box.
Replace the fuse.
The machine does not fill with water.The water tap is blocked or furred with limescale.Clean the water tap
The water tap is turned off.Turn the water tap on.
The filter (where present) in the threaded hose fitting at the water inlet valve is blocked.Clean the filter in the threaded hose fitting.
The water inlet hose has not been correctly laid or it is bent or squashed.Check the water inlet hose connection.
The dishwasher will not drain.The siphon is blocked.Clean out the siphon.
The water drain hose has not been correctly laid or it is bent or squashed.Check the water drain hose connection.
There is a whistling noise during washingThe whistling is not a cause for concern.Use a different brand of detergent.

Once the checks have been carried out, press the On/Off push button, the programme will continue from the point in which it was interrupted. If the problem reappears contact the consumer services department.

Zanussi Dishwasher Manual PDF

Add Comment

What are you looking for?